Convenient

It comes on quickly and simply by co-tightening with the OEMTool Box.
The standard wire for the Helmet holder on the CT110 HUNTER CUB is
I am glad I installed this one because it is not that good to look at. View detail

Easier to use than OEM Wire type

The M6 Hexagon Socket Bolt that holds the OEM Tool Box in place is co-tightened to two bolts, a design that is also friendly to custom beginners.
Worse, if you loosen it, the whole helmet will be stolen, so it may be safer to replace it with a tamper-proof bolt or something similar. View detail

Large difference between with and without

The CT110 HUNTER CUB does not have an external helmet holder, so I was having trouble finding a place to put my helmet when I was away from it for a while.
Thanks to this, we were able to make full use of the Top case and were satisfied with the Large change. View detail

At the time of Tandem.

Another lock is needed for Tandem and
OEMs can open Seat, take Wire out of the BOX, etc.
If you don't, it's a bit troublesome, so we chose this one.
To install, remove the two screws and insert the plate between the two screws.
Just attach 3 Screws and you are done! 10 minutes is enough time. View detail

It's still useful!

Even with the top box installed, the helmet holder is still inconvenient without it!
Although there are types that can be attached to the handlebar and the lower part of the seat, I purchased this helmet holder because I thought it would be the most convenient if the Tool Box area is used as OEM.
Still useful! Easy to use!!! View detail

Required for CT110 HUNTER CUB

The CT110 HUNTER CUB has a Helmet holder in an odd place.
I bought this DAYTONA one as it was the first thing that came up in the recommendations!
Installation is easy and can be done by one person.
It works just fine without any weird parts, so if you're not sure, just get this one! View detail

Easy Installation Single Item Quality Satisfaction

I bought this for my CT110 HUNTER CUB which has an unfriendly helmet holder.
Installation is very easy and takes only 5 minutes
Simply remove the OEM Tool Box, cotighten the Bracket, and secure the Holder.
Bolt3 will complete the story.
The quality of the product is good, and I don't feel any different when people say this is OEM.
Naturally, I have no complaints about the comfort of the product and it is very normal to use.
Anyway, it's a normal Helmet holder.

One thing to keep in mind is that if you want to install a Side Back, you'll have to do it differently! View detail