For lubrication of Axel and Clutch Wire.

[How is it used?
It was used for regular maintenance of old vehicles that were given to us and Motorcycle used for mountain activities.
In fact, it would be better to replace them with new wires, but replacing them with new ones each time would cost money and increase waste (excuse), so we are contributing to waste reduction by using this product (too painful an excuse).
Was the one you received as per Image?
I have been using this type of product for a long time, but I thought this product could be fixed more firmly than existing products because it is a two-hole type and has two Knobs for fixing.
Was the installation difficult?
Attach this product to the end of the sheathed part of each Wire, such as Axel and Clutch, and close the two fixing Knobs to make a tight fit.
After fixing, insert a nozzle of lubricant spray into the hole in the rubber (silicon?) section and pour the lubricant spray into the hole. Remove the wire injector and return the Axel and Clutch wires to their original installation state.
After the work, the injected solvent will drip for a while, so cover the surrounding area with a paper towel to absorb the solvent.
I used to work with ....
How was your experience with it?
However, the wires used in recent vehicles have a narrower diameter and a lid to prevent dirt from entering, making it more difficult to lubricate the wires.
Recently, I have been lubricating the wires by making a funnel shape with Vinyl or Gum Tape at the end of the wire and squeezing the base with a Tie Band to prevent leakage, then pouring in engine oil or sewing machine oil and leaving it until it naturally permeates the wire. This method is not effective immediately, but it does penetrate the oil.
[Included Parts:were they on?
All of the items are shown in the images in Webike's product introduction section.
[Was there anything that disappointed you?
As I mentioned above, never. All-purpose." When you try to work on a non-compatible Wire, the solvent you try to inject leaks out from everywhere and your hands get covered in solvent.
If you recognize that there are Wires you can use and Wires you can't use, you'll be able to switch quickly, so you don't have to get your hands dirtier than necessary.
Other items that would be helpful
Point and hang of installation
Firmly on the end of the WireQuantity:Set to" "Tighten both securing Knobs securely." If this leaks and does not go in, give up immediately.
[Availability and clarity of the Instruction Manual
This product is Body only and there is no Instruction Manual.
If it is difficult to understand only by text, you can use YouTube, etc. Wire injector Usage You should be able to find many candidate videos.
[Notes]
In the above, we dared to Solvents but it is stated that, for example, the CRE556 Lubricated Spray system. After a short period of time after use, the wire can dry out and wash away the oil that originally adhered to the wire, which can result in poor movement.
Silicone oil, sewing machine oil, etc. Let's try various ways.
[ITEMS TO BUY TOGETHER
Prepare a can of Spray, which contains a relatively soft oil that is long lasting, and Paper wasteetc. to wipe off excess oil.
[Opinions and requests to Manufacturer
They have always been very helpful in providing a variety of tools at reasonable lease prices, and I look forward to working with them again in the future. View detail