Check my coupons
Product Detail
Specification:
■It corresponds to intake port diameter Φ26-.
■Main Jet #135, Pilot Jet #38 are already installed.
[Product Contents]
PWK Φ28M Carburetor Assembly ×1pc.
Throttle Valve Spring (Medium) ×1pc.
Main Jet (PE/PWK/FCR) #110×1pc.
Main Jet (PE/PWK/FCR) #115×1pc.
Main Jet (PE/PWK/FCR)#120×1pc.
Pilot Jet (PE/PWK)#40×1pc.
Pilot Jet (PE/PWK)#42×1pc.
Choke Cable Assembly (PWKΦ28) ×1pc.
Fuel Hose 50cm (Pink) Φ5×1pc.
High Throttle Set (Cable Outer Length: 895mm) ×1pc.
Super Funnel Φ50×1pc.
Manifold Set×1pc.
Cap Bolt 6×15×2pcs.
Cap Bolt 6×20×2pcs.
Manifold Body ×1pc.
Manifold Packing ×1pc.
Stainless Band (Φ32-50) ×1pc.
Rubber Holder (for PWKΦ28) ×1pc.)
[Description]
This is a Keihin PWKΦ28 carburetor recommended for high-tuned engines.Φ28 large diameter and flat valve technology cultivated in the race realizes sharp acceleration.
★The works replica is the same specification as the PWKΦ28 carburetor that has been used in many races and built up many achievements.This model is designed for racing use only and cannot be used with stock frames (scooter type) or requires cylinder modification.
○The attached manifold has a larger port diameter to increase the intake air volume.
Since it is a left side exhaust, up type exhaust can be installed.
●Fits to the combination of APE engine and NSR50/80 frame.
●Compatible with Kitaco's ULTRA-SE Cylinder Head
Note
Please visit the manufacturer's website for more information about the product.
Click here for Kitako general information page.
Caution
Note: It is necessary to set up the jets according to the specification of the engine and the driving environment.The Kitaco Big Carburetor Kit uses the stock kit from the carburetor manufacturer, so please be sure to use the stock kit for setting.If you use other than the stock one, the correct setting will not be obtained and it may cause trouble.
*Stock air cleaner cannot be used.
