Based on the concept of "Serious protection for smartphones" this special model features an aluminum case machined from solid high-strength duralumin, a material used in aircraft and automotive parts, with the surface finely engraved with a special laser marker to bring out the image.
The Metal Gear Solid V collaboration model comes with a machined aluminum earphone jack cover with the V logo laser marked on it. We adopted the double anodizing process, which is not the usual anodizing process, but a two-color anodizing process. This is a special earphone jack cover that you can only get with this case.
The aluminum back protection panel can be installed and removed according to your TPO.
Caution
*This product is designed exclusively for iPhone6/6s. *Because this product is made of aluminum, radio waves will be blocked from the back of the main body.There is a possibility that the performance of receiving radio waves is slightly inferior. *This product is not designed to completely protect your iPhone from shocks.Please understand beforehand that we are not responsible for any damage to the iPhone, failure, loss, or loss of data. *This product is designed to prevent the iPhone from contacting with the case by using shock-absorbing resin, but it is not designed to completely protect the iPhone from scratches. *Please understand beforehand that we cannot assume any responsibility for any damage to iPhone caused by installing this product. *The specifications, appearance, and included products of the product are subject to change without notice. *GILD design's aftermarket chargers and earphones (the diameter of the earphone jack part is 8.5mm) may not be able to be used. *We recommend the thickness of the film to be less than 0.2mm. *Films other than the ones recommended by GILD design may cause problems such as lifting. *It may be difficult to receive the signal in the place where the signal condition is not good.If you are receiving a normal signal, there is no problem. *Due to the characteristics of the anodizing process, it is difficult to finish the same color for each lot.Tried to keep the same color as much as possible, but due to the anodizing process, the color may vary from lot to lot. *Because this product is anodized, the contact point where the electric current passes through is not colored.There are two points on the inside of the case that are not colored, but it is not a defect in processing. *Although we have made every effort to make the product photos as close as possible to the actual color of the product, you may notice a change in color depending on your computer monitor, color settings, indoor lighting, sunlight, and other factors.
