- Home
- Motorcycle Parts
- Bodyworks
- Emblems
- SP Takegawa
- SP Takegawa: Convex Emblem
Check my coupons
Product Detail
Specification:
[Size]
Large Size: Approximately 120mm x Approximately 18mm Thickness Approximately 1.6mm
Small Size: Approximately 60mm x 9mm Thickness Approximately 1.8mm
Quantity: 1 Set of 4pcs. (Large/Small 2-types 2pcs./each)
Large Size: Approximately 120mm x Approximately 18mm Thickness Approximately 1.6mm
Small Size: Approximately 60mm x 9mm Thickness Approximately 1.8mm
Quantity: 1 Set of 4pcs. (Large/Small 2-types 2pcs./each)
[Description]
This is a three-dimensional emblem that can be attached to the gas tank, side cover, etc. as a one-point accessory.
The body is made of plastic, and the surface of the letters is plated.
Strong exterior double-sided tape is attached to the back of the emblem.
Plating is available in silver and gold.Two large and two small, total 4 pieces per set.
[Advice]
The strong adhesive sheet is used, so please check the position of the adhesive sheet carefully before installation.
If there is water, oil, dust, or wax on the surface, the adhesive strength will become extremely poor, so be sure to thoroughly clean and degrease the adhesive surface.
When working in a low temperature environment (below 5 degrees Celsius), warm up the adhesive sheet a little before working in order to strengthen the initial adhesive strength.
After pasting, please press well from the top to strengthen the adhesive force.Please do not wash your car or drive in the rain for 1 or 2 days after application.
The body is made of plastic, and the surface of the letters is plated.
Strong exterior double-sided tape is attached to the back of the emblem.
Plating is available in silver and gold.Two large and two small, total 4 pieces per set.
[Advice]
The strong adhesive sheet is used, so please check the position of the adhesive sheet carefully before installation.
If there is water, oil, dust, or wax on the surface, the adhesive strength will become extremely poor, so be sure to thoroughly clean and degrease the adhesive surface.
When working in a low temperature environment (below 5 degrees Celsius), warm up the adhesive sheet a little before working in order to strengthen the initial adhesive strength.
After pasting, please press well from the top to strengthen the adhesive force.Please do not wash your car or drive in the rain for 1 or 2 days after application.
Caution
Convex Emblem
ALSO VIEWED PRODUCTS
Apply Coupon
Image Review
Review detail
/