- Beranda
- Motor
- HONDA 0 - 50cc
- DAX ST50
- Sparepart Motor
- Suspensi / Rearset / Velg / Swingarm
- Swingarm
- GM-MOTO
- GM-MOTO: [KEPPEED] Swingarm Aluminium Tipe G2F
[KEPPEED] Swingarm Aluminium Tipe G2F
- Nomor produk: dax-00018
-
- IN STOCK
- Out Stock
-
- |
- 0.0
- (0 ulasan)
Cek kupon saya
Jumlah
100% Ori
Garansi 7 hr
Gratis Cashback
Nett Tanpa Biaya Tambahan
Model yang Sesuai
Lihat SemuaRincian Produk
Konten ini diterjemahkan oleh Google, jika Anda ingin melihat aslinya, silakan klik
Lihat versi asli
[Deskripsi]
Tipe GF terbaru dengan penampang heksagonal ultra tebal dan dengan stabilizer!
Swingarm tipe GF untuk Daks dan Chaly telah dirilis dan tersedia dengan stabilizer!
Bagian pivot telah ditingkatkan dengan suku cadang mesin CNC, dan peralatan stabilizer telah ditambahkan.
Semua bagian terbuat dari aluminium CNC padat kecuali pipa utama yang membutuhkan bantalan jarum di porosnya.
Panjang ekstensi +2cm.
Spatbor sangat serasi dengan spatbor helm.
Lengan ayun ini adalah produk KEPSPEED, produsen suku cadang aluminium berkualitas tinggi.
■ Ulasan Egois Staf GM
Swingarm terbuat dari aluminium padat untuk bagian utama, dan pipa utama terbuat dari pipa berpenampang heksagonal, dan stabilizer diperkuat dengan pipa yang cacat juga.
Kami yakin bahwa ini akan memenuhi semua kebutuhan pelanggan kami dan akan memungkinkan mereka untuk menciptakan mesin yang paling kuat yang pernah ada. The newest GF type with ultra thick hexagonal cross section and with a stabilizer!
GF type swingarm for Daks and Chaly has been released and available with stabilizer!
The pivot section has been upgraded with CNC machined parts, and stabilizer equipment has been added.
All parts are made of solid CNC aluminum except for the main pipe, which requires a needle bearing at the pivot.
Extension length is +2cm.
The fenders are well matched with the helmet fenders.
This swingarm is a product of KEPSPEED, a manufacturer of high quality aluminum parts.
■GM Staff Selfish Review
The swingarm is made of solid aluminum for the main parts, and the main pipe is made of hexagonal figure-section pipe, and the stabilizer is reinforced with a deformed pipe as well.
We are confident that this will meet all of our customer's requirements and will allow them to create the most powerful machine ever.
Swingarm tipe GF untuk Daks dan Chaly telah dirilis dan tersedia dengan stabilizer!
Bagian pivot telah ditingkatkan dengan suku cadang mesin CNC, dan peralatan stabilizer telah ditambahkan.
Semua bagian terbuat dari aluminium CNC padat kecuali pipa utama yang membutuhkan bantalan jarum di porosnya.
Panjang ekstensi +2cm.
Spatbor sangat serasi dengan spatbor helm.
Lengan ayun ini adalah produk KEPSPEED, produsen suku cadang aluminium berkualitas tinggi.
■ Ulasan Egois Staf GM
Swingarm terbuat dari aluminium padat untuk bagian utama, dan pipa utama terbuat dari pipa berpenampang heksagonal, dan stabilizer diperkuat dengan pipa yang cacat juga.
Kami yakin bahwa ini akan memenuhi semua kebutuhan pelanggan kami dan akan memungkinkan mereka untuk menciptakan mesin yang paling kuat yang pernah ada. The newest GF type with ultra thick hexagonal cross section and with a stabilizer!
GF type swingarm for Daks and Chaly has been released and available with stabilizer!
The pivot section has been upgraded with CNC machined parts, and stabilizer equipment has been added.
All parts are made of solid CNC aluminum except for the main pipe, which requires a needle bearing at the pivot.
Extension length is +2cm.
The fenders are well matched with the helmet fenders.
This swingarm is a product of KEPSPEED, a manufacturer of high quality aluminum parts.
■GM Staff Selfish Review
The swingarm is made of solid aluminum for the main parts, and the main pipe is made of hexagonal figure-section pipe, and the stabilizer is reinforced with a deformed pipe as well.
We are confident that this will meet all of our customer's requirements and will allow them to create the most powerful machine ever.
Peringatan
*Karena perubahan spesifikasi dari pabrikan (dari kedatangan Juli 2020) , saham Dax / Hub Chaly sekarang dapat digunakan.Namun, roda yang tersedia akan menjadi ukuran stok.Jika roda lebar akan digunakan, diperlukan modifikasi terpisah.Untuk informasi lebih lanjut, silakan hubungi toko khusus yang berspesialisasi dalam Dax / Chaly.
※ Poros poros stok tidak dapat digunakan. Harap siapkan poros panjang dengan panjang leher 240mm atau lebih. Poros poros panjang dapat dibeli secara terpisah di GM-MOTO.
*Rantai penggerak perlu diperpanjang karena panjang lengan ayun diperpanjang.Jumlah depan rantai penggerak tergantung pada kondisi kendaraan pelanggan dan sproket depan dan belakang, dan GM-MOTO tidak memberikan informasi ini.Selain itu, tergantung pada spesifikasi kendaraan pelanggan, ban dapat bersentuhan dengan fender atau bagian lain dari kendaraan.
*Bahkan jika suspensi belakang berada di bawah penuh, pastikan untuk memeriksa titik kontak yang tidak normal.
*Jika celah antara rangka dan lengan ayun lebih dari 0,5 mm di setiap sisi, harap gunakan washer untuk mengurangi celah. Jika poros pivot dikencangkan dengan celah yang besar, lengan ayun akan mengalami beban tinggi dan mungkin rusak dalam kasus terburuk.
Mungkin ada beberapa perubahan spesifikasi kecil untuk setiap produk. Mungkin ada beberapa poin yang sedikit berbeda dari gambar pengenalan.
Setelah mulai berkendara, perhatikan terjadinya apa yang disebut kelonggaran awal dan lakukan inspeksi secara berkala untuk mencegah masalah yang tidak terduga.
* Karena dibuat di luar negeri, pencetakan, pengelasan, pengecatan, dll. mungkin tidak cukup. Mungkin ada beberapa goresan dan lecet kecil karena masalah transportasi.
*Mungkin ada perubahan spesifikasi produk karena alasan pabrikan.
[Catatan tentang pembelian]
*Semua produk GM-MOTO adalah suku cadang khusus. Karena produk ini dibuat sebagai tanggapan atas permintaan pengguna berat, mungkin ada bagian produk yang berubah atau menurun dari performa berkendara aslinya. Silakan gunakan sebagai suku cadang tambahan untuk tampilkan mesin model.Oleh karena itu, tidak cocok untuk dikendarai di jalan atau trek umum.Dalam beberapa kasus, unit tidak dapat dipasang di sepeda motor, atau penyesuaian dan modifikasi mungkin diperlukan di berbagai area.
*Due to a specification change on the part of the manufacturer (from July 2020 arrival), stock Dax / Chaly hubs can now be used.However, the available wheels will be stock size.If wide wheels are to be used, separate modification is required.For more information, please contact a custom store that specializes in Dax / Chaly.
※ Stock axle shafts cannot be used.Please prepare a long shaft with a neck length of 240mm or longer.Long axle shafts can be purchased separately at GM-MOTO.
*The drive chain needs to be extended due to the extended swingarm length.The number of drive chain fronts depends on the condition of the customer's vehicle and the front and rear sprockets, and GM-MOTO does not provide this information.In addition, depending on the specifications of the customer's vehicle, the tires may come in contact with the fender or other parts of the vehicle.
*Even if the rear suspension is at full bottom, be sure to check for any abnormal contact points.
*If the gap between the frame and the swingarm is more than 0.5mm on each side, please use washers to reduce the gap.If the pivot shaft is tightened with a large gap, the swingarm will be subjected to a high load and may be damaged in the worst case.
※ There may be some minor specification changes for each product.There may be some points that differ slightly from the introduction image.
※ After the start of riding, pay attention to the occurrence of so-called initial loosening and perform frequent inspections to prevent unexpected problems.
*Because it is made overseas, the molding, welding, painting, etc. may be insufficient.There may be some minor scratches and scuffs due to transportation problems.
*There may be changes in product specifications due to the manufacturer's reasons.
[Notes on purchase]
*All GM-MOTO products are custom parts.Since these products are set up in response to the requests of heavy users, there may be parts of the product that change or decrease from the original driving performance.Please use as dress-up parts for show model machines.Therefore, it is not suitable for driving on public roads or tracks.In some cases, it may not be possible to mount the unit on a motorcycle, or adjustments and modifications may be required in various areas.
※ Poros poros stok tidak dapat digunakan. Harap siapkan poros panjang dengan panjang leher 240mm atau lebih. Poros poros panjang dapat dibeli secara terpisah di GM-MOTO.
*Rantai penggerak perlu diperpanjang karena panjang lengan ayun diperpanjang.Jumlah depan rantai penggerak tergantung pada kondisi kendaraan pelanggan dan sproket depan dan belakang, dan GM-MOTO tidak memberikan informasi ini.Selain itu, tergantung pada spesifikasi kendaraan pelanggan, ban dapat bersentuhan dengan fender atau bagian lain dari kendaraan.
*Bahkan jika suspensi belakang berada di bawah penuh, pastikan untuk memeriksa titik kontak yang tidak normal.
*Jika celah antara rangka dan lengan ayun lebih dari 0,5 mm di setiap sisi, harap gunakan washer untuk mengurangi celah. Jika poros pivot dikencangkan dengan celah yang besar, lengan ayun akan mengalami beban tinggi dan mungkin rusak dalam kasus terburuk.
Mungkin ada beberapa perubahan spesifikasi kecil untuk setiap produk. Mungkin ada beberapa poin yang sedikit berbeda dari gambar pengenalan.
Setelah mulai berkendara, perhatikan terjadinya apa yang disebut kelonggaran awal dan lakukan inspeksi secara berkala untuk mencegah masalah yang tidak terduga.
* Karena dibuat di luar negeri, pencetakan, pengelasan, pengecatan, dll. mungkin tidak cukup. Mungkin ada beberapa goresan dan lecet kecil karena masalah transportasi.
*Mungkin ada perubahan spesifikasi produk karena alasan pabrikan.
[Catatan tentang pembelian]
*Semua produk GM-MOTO adalah suku cadang khusus. Karena produk ini dibuat sebagai tanggapan atas permintaan pengguna berat, mungkin ada bagian produk yang berubah atau menurun dari performa berkendara aslinya. Silakan gunakan sebagai suku cadang tambahan untuk tampilkan mesin model.Oleh karena itu, tidak cocok untuk dikendarai di jalan atau trek umum.Dalam beberapa kasus, unit tidak dapat dipasang di sepeda motor, atau penyesuaian dan modifikasi mungkin diperlukan di berbagai area.
*Due to a specification change on the part of the manufacturer (from July 2020 arrival), stock Dax / Chaly hubs can now be used.However, the available wheels will be stock size.If wide wheels are to be used, separate modification is required.For more information, please contact a custom store that specializes in Dax / Chaly.
※ Stock axle shafts cannot be used.Please prepare a long shaft with a neck length of 240mm or longer.Long axle shafts can be purchased separately at GM-MOTO.
*The drive chain needs to be extended due to the extended swingarm length.The number of drive chain fronts depends on the condition of the customer's vehicle and the front and rear sprockets, and GM-MOTO does not provide this information.In addition, depending on the specifications of the customer's vehicle, the tires may come in contact with the fender or other parts of the vehicle.
*Even if the rear suspension is at full bottom, be sure to check for any abnormal contact points.
*If the gap between the frame and the swingarm is more than 0.5mm on each side, please use washers to reduce the gap.If the pivot shaft is tightened with a large gap, the swingarm will be subjected to a high load and may be damaged in the worst case.
※ There may be some minor specification changes for each product.There may be some points that differ slightly from the introduction image.
※ After the start of riding, pay attention to the occurrence of so-called initial loosening and perform frequent inspections to prevent unexpected problems.
*Because it is made overseas, the molding, welding, painting, etc. may be insufficient.There may be some minor scratches and scuffs due to transportation problems.
*There may be changes in product specifications due to the manufacturer's reasons.
[Notes on purchase]
*All GM-MOTO products are custom parts.Since these products are set up in response to the requests of heavy users, there may be parts of the product that change or decrease from the original driving performance.Please use as dress-up parts for show model machines.Therefore, it is not suitable for driving on public roads or tracks.In some cases, it may not be possible to mount the unit on a motorcycle, or adjustments and modifications may be required in various areas.
PRODUK YANG JUGA DILIHAT
Produk Siap Dikirim dari Gudang Jepang
Rekomendasi buat Kamu
Best Seller
New Custom Article
Gunakan kupon
Review Gambar
Review detail
/