MOTION Motion Fork Decal SHOWA

It covers the entire circumference of the Fork that I want to install, which gives me a sense of security and good feeling. View detail

Very solid.

The Fork decal you are putting up now is KAYABA.
But isn't it still KYB? (Laughs)
So. when I tried to buy FX's Fork decal,
What a surprise, it will take a month or two (laughs).

So, I just bought this one.
Material is thick and solid. 3M.
I'm glad I bought this one.

With PeLePera, you can't expect durability, right? View detail

3pcs in 1set, before quantity:Pair (for Left and Right) Cost-effective and can be affixed to

[How is it used?
Dress-up of my car?

Was the one you received as per Image?
I think it is as per Image.

How was your experience with it?
Some places to paste the Number Plate may be curved, so it is better to paste the Number Plate on a flat surface if possible,

[Points to note]
The area where the Number Plate is to be applied should be degreased and wiped clean.
How was your experience with it? As mentioned in the previous section, it is better to use a heat gun to warm up the paste before slowly applying it to places where the paste surface is not flat or curved.

How did it compare to other products?
The price is low and there are 3 pieces in 1 SET, so Upper Cowl and Quantity on the front:Pair (for Left and Right) It is good because it can be attached to the Cowl of

Other items that would be helpful
Installation points and hang/Items to buy together/ Opinions and requests to the Manufacturer
It is recommended to degrease and wipe the area to be used for affixing the Number Plate beautifully in advance.
If the surface is not flat or curved, it is better to warm it up with a heat gun before applying the paste slowly. View detail

Upgrade suspension

Good for dress-up around the rear area.:Rather than gray, it is more in tune with the color of the Swing Arm and is closer to silver. It is thick and durable. View detail

for RaceNumber Plate

[How is it used?
I purchased this as a SIDE and UnderNumber PlateSticker for Road race.

How was your experience with it?
I usually use a Number Plate Sticker from KITACO, but Webike discontinued it, so I looked for something close and bought it. 9 was the Number Plate, but Sticker 6 was in stock, so I used 6 upside down.

How did it compare to other products?
I think the numbers are longer and narrower than the Sticker I used to use, perhaps for Off purposes? I think the numbers are longer and narrower.
Also, the thickness of Sticker seems a bit thick.

[Points to note]
When I put it on the part with R, air gets in and it is hard to put it on well, so I use heat gun and struggle more than usual Sticker.
Especially, when I want to sticker to Seat Cowl, my Motorcycle needs to cut the sticker,
I had a hard time putting it on well. (Even after it was pasted, the workmanship was not good.) View detail